jd 750 drill hitch

Posted Wed, 01/27/2010 - 00:21 by sri

we made a hitch to pull packer or whatever behind the drill. Pictures are kinda self explanatory. the main hitch drawbar is 7/8 by three inches wide it was bent to go aroud the weight bracket pin. Hydraulic lines behind are to pick up packer and run hyd. motor for loading from wagon. They are tied into the markers with two ball valves.

Also for us less than mobile folks we added a step extension to the side of the drill,did this by bending a lenght of flat steel so it fits down and around the original. as you can see it was done by roy.

Also posted on different wiki page is the drill support for the center bearing,don't know how many would find it there so trying to move it over here.

It fixes the problem of broken center bearings on some 750 drills by adding a support piece to existing bolts.

Attachment	Size
!cid_000d01ca9f06$3267bd00$FA157200@StuartPC.jpg	30.18 KB
!cid_000c01ca9f06$3266f9b0$FA157200@StuartPC.jpg	34.1 KB
!cid_000e01ca9f06$32688050$FA157200@StuartPC.jpg	33.96 KB
!cid_000c01c82572$3c57ddf0$C496CCA7@StuartPC.jpg	31.16 KB
!cid_000d01c82572$3c5a00d0$C496CCA7@StuartPC.jpg	32.78 KB